Check Dip Switches

Check Dip Switches

If your USB emulator is not working, it might be your dip switches.  The dip switches are configured for different types of equipment or machines.  Please contact our technical support department for correct pin configuration based on the equipment the  emulator will be installed in.

Our most common drive is the USB-A001.  The dip switches for A001 should be set with 1, 2, and 7, and 8 turned ON.  All other switches should be turned off.

The switches can be turned on or off using a small screwdriver or paperclip.  On the circuit board, the words ON and OFF are printed near the switches including the corresponding numbers per switch.

Dip switch 5 changes between drive A and drive B, if we think there is a dip switches problem.

FDD2USB Customer Support

<<<Back to the Floppy to USB Support Page