Convert your Sodick floppy drive to a USB reader! This floppy emulator will help you eliminate floppy disks! BUY NOW Combine it with our WIRELESS USB STICKS for Sodick machines. The following codes are used when ordering your USB upgrade. SODICK 812 USB-HYYY Sodick A280 USB-HZ09 SODICK A320D USB-HZ09 SODICK A320D with EX21 Control USB-H009 Sodick […]
Convert your HAAS floppy drive to a USB reader! This floppy emulator will help you eliminate floppy disks! BUY NOW Combine it with our WIRELESS USB STICKS for HAAS machines. The following codes are used when ordering your USB upgrade. HAAS HL2 Lathe USB-A001 HAAS Machine USB-A001 HAAS Mini Mill USB-A001 […]
Here is some information that I think might be helpful for you: USB Floppy Drive Introduction: Thanks for the purchase! Our USB Floppy drive is intended to be a drop in replacement for your original floppy drive. It will pretend to be your floppy drive exactly and make passing files to and from your machine […]
USB Flash Reader Embroidery Machine Transfer System Manual
Troubleshooting Questionnaire Are the cables connected properly? Getting a constant green and red light at power up? Is the red side (pin1 side) of the ribbon cable towards the power cable? -The ribbon cable may be inverted or cables are not connected properly. See the “How to Install a USB Floppy Drive” PDF document online […]
Floppy Drive Upgrade to USB Drive – Standard 3.5 inch A very Easy Floppy to USB Upgrade CLICK HERE TO BUY NOW Eliminate your need for 3 ½ floppies with this 3 ½ floppy-to-USB disk drive! Our 3 ½ floppy disk drive to USB flash drive reader converter will replace your existing floppy drive with […]
Red light is always on If the red light on your Floppy to USB emulator is always on, please try the following Check Ribbon Cables Check Power Cables Reformat USB Try a different USB Stick Check light behavior Check Dip Switches <<<Back to the Floppy to USB Support Page
Check Ribbon Cables Check Power Cables If your USB reader is not reading properly, you might check the power and ribbon cables. The power cable typically has a notch in it to ensure its not plugged in backward. The positive power cable, which is typically red, should be plugged into the pin closest to the […]
Check light behavior if your USB and emulator are working properly, the red light should flash when the stick is plugged in. if your stick has a light, it should also light up. When reading from the stick, the green light should flash. If the lights do not behave in this manner, please check your […]
Check Dip Switches If your USB emulator is not working, it might be your dip switches. The dip switches are configured for different types of equipment or machines. Please contact our technical support department for correct pin configuration based on the equipment the emulator will be installed in. Our most common drive is the USB-A001. […]