Okuma osp-e100l

[catohagen]

Hi,

Just wanted to say floppy emulator works with OSP-e100L

dip switches

1-2-3 on
4 off
5 on
6 off
7-8 on

1.44mb floppy size

[plrelectronics]

Thanks for the feedback!!!

[ForrestErickson]

I can confirm the settings for the OSP-E100L, this took 20 min to change out the old floppy drive and install the USB upgrade, worked perfectly.

I also tried this on our older lathes, the OSP-7000L and did not find a configuration that would work, the best I could find was
1-off
2-on or off
3-off
4-on or off
5-must be on
6-on or off
7-on
8-on

With 1 and 3 off I got the green and red light to blink when the machine tried to access the drive, but I got an error saying the floppy was not ready. If I turned 5 off no lights would come on at all and I would get a floppy time out error.

It is interesting that both controllers use the exact same model of floppy drive, a YE DATA YD-702D-6639D, but for some reason I could not get the older controller to recognize the floppy emulator. And yes the older machine uses DOS to access/copy files to and from the floppy drive.